We all know that engineering drawings can be pretty confusing, but did you know that they can also be really helpful in understanding how to put together different parts? In this tutorial, we’ll show you how to draw a nut and bolt in engineering drawing, using a few simple steps.
First, let’s take a look at the different parts of a nut and bolt. The nut is the part that screws onto the bolt, and the bolt is the part that goes through the hole in the object that you’re trying to fasten together. In order to fasten the two parts together, you’ll need to screw the nut onto the bolt.
Now that we know the basics, let’s get started with the tutorial. First, we’ll start with the bolt. Draw a long, thin rectangle that’s slightly curved at the top. This will be the body of the bolt.
Next, we’ll add the head of the bolt. This is a small circle that’s attached to the top of the bolt’s body.
Now, we’ll move on to the nut. Draw a small, oval-shaped object that’s slightly flattened on one side.
Finally, we’ll add the threads to the bolt. To do this, simply draw a series of small, curved lines going around the body of the bolt. Make sure that the lines are evenly spaced, as this will make it easier to screw the nut onto the bolt later on.
And that’s it! You now know how to draw a nut and bolt in engineering drawing. With a little practice, you’ll be able to put together any object that you need to.
Other related questions:
Q: How do you sketch a nut?
A: There is no one “right” way to sketch a nut, but one approach is to start with a basic oval shape. Then, add two smaller oval shapes on either side for the halves of the nut. Finally, add lines to indicate the ridges on the surface of the nut.
Q: What is bolt in drawing?
A: A bolt is a fastener that is used to hold two or more pieces of material together.
Q: How do you draw a bolt head?
A: There are a few different ways that you can draw a bolt head. One way is to start with a circle and then add two lines perpendicular to each other in the middle of the circle. Then, add two more lines coming out from the sides of the circle and meeting in the middle. Finally, add a line across the middle of the circle.
Q: How do you draw a m10 bolt?
A: There is no definitive answer to this question, as it depends on the specific dimensions and tolerances of the bolt in question. However, a general guide to drawing a m10 bolt would be as follows:
1. Begin by drawing a rectangle to represent the bolt’s shank. This rectangle should be slightly longer than it is wide, and its width should be equal to the diameter of the bolt.
2. Next, draw a smaller rectangle at one end of the shank, representing the bolt’s head.
3. Finally, add any other details as necessary, such as the threading on the bolt’s shank, and the hexagon-shaped recess on the bolt head.